Big Popeye how to inject anabolic steroids painless inections

1 w 2 w 3w 4 w 5 w 6 w7

How to inject anabolic steroids

" There is an almost inexplicabe paranoia around the whole subject of syringes and injections. Those who take intramuscuar injections know that there is little or no pain "
Paul Borresen
Parmacolgist

Lets be fair ! If you have ever given blood at the doctors you will know that the shart pierce of the needle in your vein is very annoying.
Fortunately steroid injections are not put into the vein of the four-arm but the muscle of the upper arm .
The upper arm muscle has few nerve endings and so it does not transmit pain to the brain

Steroid injections are known as intramuscular which denotes an injection into the muscle as apposed to a vein which is called intravenous .

Intravenous injections can be messy and sharp but intramuscular injections are nothing to worry about.

For sure when you have overcome the psychological barrier of the first injection you will wonder what all the fuss is about.

The injection we show here is in the arm but you can also inject in the glutes (buttux) . If you do this aim mid center .

The upper arm has few nerve endings and so it is a good place to inject.

Simply hold the syringe over the
target area and dart in. At first your natural defenses will mean you will hold back and the needle will go halfway in. If this is the case just push slowly in to the hilt.

It is the case that the faster you dart the needle in the less sensation you will feel.

The worst pain you can experience is a mild sting . Mostly nothing at all.

Sometimes you may split a muscle fibre and this may cause a dull pain as you inject . If this happens and you feel unconfortable abort the injection and try again.

One absolute rule : never to be broken is that you must protect the needle from dirt before entry.
If you drop the needle on the floor or carpet immediately bin it.
If you do not you may suffer fatal consequences .

The needle has a plastic cover so
make sure when this is removed the needle goes direct into the target area.
Never resuse needles.

In photo 6 you see the fluid being drained with the syinge. If the needle wont reach the bottom simply invert the bottle so that the
bottle is on top and the syringe underneath.
The fluid will then settle in the neck of the bottle .
Just make sure the tip of the needle is submerged in the fluid.

You do not need to pump the barrel of the syringe. Just pull it back once and you will feel a stong spring action. Hold the barrel firm and you will see the solution drain into the syringe .

There are markers on the syringe so you can see how much is going in.

When you press the solution into the muscle there will be resistence.
Push very hard but slowly on the barrel to force the solution into the muscle.

After the injection replace the plastic cap to the needle and dispense with the syringe and needle .